ECOTAP® VPD® Control
"ECOTAP® VPD® Control"
Your Advantages at a Glance
Control unit for voltage regulation with operating and display elements. The control unit triggers a load changeover via the ECOTAP® VPD® on-load tap-changer when the motor-drive unit is actuated.
Single-phase automatic
- Automatic operation with single-phase voltage control algorithm
Simple configuration
- Parameterization possible without a laptop
User-friendly
- Extensive status indicators on the display
Plug-and-play
- Connection completely via plug
ECOTAP® VPD® Control
Suitable for all versions of the ECOTAP® VPD® on-load tap-changer
- Only 10 cm wide and 35 cm high
- Degree of protection IP30 (housing required for outdoor installation)
- Voltage range: 100....240 VAC
- Modbus-RTU interface
What you get:
- 1 box with ECOTAP® VPD® Control
- 1 nameplate sticker
Dokumente
| Name | Kategorie | Datum | Größe | Download |
|---|---|---|---|---|
ECOTAP® VPD® Control Betriebsanleitung |
Operating instructions | 5.10.2023 | 531 KB |
 |
FAQ - Frequently Asked Questions
What is the difference between the "Standard" and the "e.on" variant?
The "e.on variant" has Modbus-specific parameter settings especially for the distribution network operator e.on. Externally, there is no discernible difference, and both variants are functionally identical.
Can the ECOTAP® VPD® on-load tap-changer with motor-drive unit also be operated WITHOUT a control unit?
No, the mode of operation, including the energy storage unit built into the control unit, requires the use of the control unit supplied by MR.
Can a standard control unit be replaced by a Control DS control unit?
Yes, the hardware and software functions are the same, the Control DS has an additional input for 1-phase current measurement and extended functionalities.
What does the "DS" in Control DS stand for?
It stands for "Dynamic Setpoint Adjustment", depending on the active power flow. This function was previously available as 'TDSC' in a separate software called 'CONTROL PRO'.